| |
Electrical Specifications |
| |
Voltage range |
|
0 V - 60 V |
| |
Current range |
|
0 A - 20 A |
| |
Power range |
|
Up to 420 W per output - see PowerFlex power envelope graph |
| |
OVP range |
|
10% - 110% of maximum output voltage |
| |
Voltage setting |
|
By coarse and fine controls |
| |
Current setting |
|
By single logarithmic control |
| |
Line and Load regulation |
|
<0.01% of maximum output for a 10% line chang; <0.05% of maximum output for a 90% load change. |
| |
Output impedance |
|
Typically <5mW in constant voltage mode. Typically >5kW in constant current mode (voltage limit at max.) |
| |
Ripple and noise |
|
5 mV rms max, typically 1 mV rms, <10 mV pk-pk, (20 MHz bandwidth) both outputs full loaded (10A @ 42 V), CV mode. |
| |
Transient response |
|
<200ms to within 50 mV of set level for 90% load change |
| |
Output protection |
|
Forward protection by OVP trip; maximum voltage that should be applied to the terminals is 50 V. Reverse protection by diode clamp for reverse currents up to 3 A. |
| |
Temperature coefficient |
|
Typically <100ppm/oC |
| |
Status indication |
|
LED indication of Output On, CV, CI and Power Limit. Message on display for over-voltage trip |
| |
Output switch |
|
Push-push switch operating electronic power control. Preset voltage and current are displayed when the output is off. |
| |
Output terminals |
|
4mm terminal on 19mm (0.75") pitch. 30 A max. rating |
| |
Sensing |
|
Remote sensing via a front panel terminal block or local sensing (at output terminals). Selection by slide switch |
| |
Meter resolution |
|
10 mV, 10 mA |
| |
Meter accuracy: |
|
|
| |
Voltage |
|
0.2% +/- 1 digit |
| |
Current |
|
0.5% +/- 1 digit |
| |
General Specifications |
| |
AC Input |
|
115 V - 240 V AC +/- 10%
50/60 Hz. Installation Category ll |
| |
Power consumption |
|
600 VA max. |
| |
Operating temperature range |
|
5°C to 40oC, 20 to 80% RH |
| |
Storage range |
|
-40oC to + 70oC |
| |
Environmental |
|
Indoor use at altitudes up to 2000m, Pollution Degree 2 |
| |
Safety |
|
Complies with EN61010-1 |
| |
EMC |
|
Complies with EN61326 |
| |
Dimensions (HxWxD) |
|
5.1 x 8.3 x 14.8" (130 x 210 x 375mm) |
| |
Weight |
|
11 lbs. (5kg) |
| |
Warranty |
|
3 years |
| |
Power Envelope (each output) |
| |
 |
| |
The maximum current at any voltage setting is limited by the power envelope which is set to give 7 A at 60 A rising to 20 A at 20V (both outputs loaded). |
| |
At lower output voltages the power is restricted by the 20 amp maximum current. |
| |
|
|
|
| |
Regulatory Approvals |
| |
CE-marked units meet: EN61010-1 and EN61326 |
| |
| Note: Specifications subject to change without notice. |
